msn:sales01 at auto2tech com
skype:auto2tech


1.THIS POWER SUPPLY IS SPECIALLY FOR BMW OPS PROGRAMMING.
USUALLY FOR PROFESSIONAL PROGRAMMING FOR NEW BMW AND MAINTAINING COSTANT VOLTAGE AND CURRENT DURING VEHICLE ASSEMBLEY TO PROGRAMMING.
During programming power levels must be maintained in a narrow range to minimize the chance of damaging controllers. It must be adjusted voltage between 12.8 till 13.5 Volt before connect power cable to car battery. There is a LCD Monitor to show the statistics .
It is no need to run a car to supply for permanent and stable voltage.
It can adjust the AC and DC .It is very strong and stablization.
Recommended by almost all manufacturers from BMW and Mercedes Benz to Volvo, Porsche, Volkswagen, Audi, Mann and many others.
Not a Battery Chargers .

2.You have to use Uninterrupted Power Supply when you replace the battery jar of a car, which reduce unnecessary troubles caused by power turn-off. Potential troubles are as follows:
1)Reset time/date on dashboard
2)Reset audio code
3)Reset throttle valve
4)Reset burglar alarm
avoid malfunctions caused by power turn-off
The task of replacing car battery easy to accomplish if you use UPS.
All car types are applicative.

3.Using Instructions:
Firstly, you can insert 16 pin plug of UPS into car diagnostic connector, which LED light that on the left of 16pin plug will turn green. Secondly, you can clip positive and negative charges of standby battery on another port of UPS, which both of LED lights turn green. At this moment, you can replace the battery. Importantly, you need to ensure if the battery has enough power, or it can influence the task of replacing. The LED light will turn red when the battery is short of power